![]() The Startup Manager screen works like the BIOS screen on a laptop, in that it gives the drive power without any data throughput.ġ. This will boot the Mac to the Startup Manager screen. ![]() In addition, Apple users must hold the Option key while they power on the system (with the SSD installed). For laptops, we don’t recommended using a USB enclosure powered via USB. (Please refer to your system manufacturer’s documentation on how to access the BIOS.) Allowing the drive to sit in the BIOS will improve the odds that the power cycle will work. You can find our firmware update page here.Ī laptop computer will also work, but you’ll have to connect the drive and navigate to the system's BIOS menu. If the latest firmware has not been updated to your drive, do so. Reconnect the drive normally, and boot the computer to your operating system.ĥ. Reconnect the drive, and repeat steps 1 and 2 one more time.Ĥ. Power the computer down and disconnect the drive from the power connector for 30 seconds.ģ. We recommend that you don't use the computer during this process.Ģ. Once you have the drive connected and sitting idle, simply power on the computer and wait for 20 minutes. Apple and Windows desktop users follow the same steps.ġ. However, a USB enclosure with an external power source will also work. We recommend you perform this procedure on a desktop computer because it allows you to only connect the SATA power connection, which improves the odds of the power cycle being successful. In most cases, your SSD can be returned to normal operating condition by completing a power cycle, a process that will take approximately one hour. Computer Bios dont recognize it even connected to motherboard sata port.Ī sudden power loss is most common cause for a system to fail to recognize an SSD. Suddenly "no ssd", when turning on the camera after a interview. I just pull it out of the BMCC and put it back in and then it mounts. Yes my Samsung 840 pro 256g do have problems with no SSD in camera. Marcel Beck wrote:Hello Blackmagic & Fellow Users, I do not believe it to be a camera issue as I used the same SSDs for the entire day without turning the camera off, it focuses more on excessive boot ups and power downs. Note: You need to redock the SSD and safely eject it to use it with the camera again. My question is, did anyone else run into this NO SSD warning after turning the camera on/off several times? Typically are you not supposed to turn it on and off like a spastic child? On my Samsung 512SSD It came with a spacer that I stuck onto the SSD to bring it back to 9.5mm, It seemed to work until I was back in the field Runnin'n'gunnin, turned the camera off a few times only to see the warning again. I had a talks with a few reps, and came to the conclusion that it could be that the SSD has enough 'play' within the SSD Bay with the 7mm thickness compared to what SSD's usual thickness of 9.5mm (see picture below) It happens when I turn on and off the camera several times over a period of few minutes, a typical scenario when your trying to save the internal battery and shoot only what you need. So I ran into a small occurrence with the NO SSD warning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |